GFCI requirements are the part of the electrical code that touches almost every room in your house, and they have grown with every edition of the NEC. A kitchen that passed inspection ten years ago can have receptacles today that would need GFCI protection if they were installed new. Outdoor air conditioners and heat pumps joined the list this September. And a 240 volt dryer outlet can now need the same protection as the outlet next to your bathroom sink.
Here is where the NEC wants GFCI protection in a home, what changed recently, and what that means for a house that is already built.
What a GFCI actually does
A GFCI, short for ground fault circuit interrupter, compares the current going out on the hot conductor with the current coming back on the neutral. Normally they are equal. If a few milliamps are missing, that current is leaking somewhere else, possibly through a person standing on a wet floor. At a difference of about 5 milliamps, the GFCI trips, fast enough to prevent a fatal shock.
A GFCI does not protect against overloads or short circuits; that is the job of the breaker. It also does not detect arcing in damaged wiring; that is what an AFCI does. A dual function breaker combines GFCI and AFCI protection in one device.
GFCI requirements by room under the 2023 NEC
Section 210.8(A) of the 2023 NEC lists the places in a home where receptacles need GFCI protection. The rule covers all 125 volt through 250 volt receptacles on single phase branch circuits of 150 volts or less to ground, which in a normal house means both your 120 volt outlets and your 240 volt outlets.
| Location | What needs GFCI protection |
|---|---|
| Bathrooms | Every receptacle |
| Kitchens | Every receptacle in the kitchen, not only the ones above the countertop |
| Wet bars and similar areas | Areas with a sink and permanent provisions for food or drink preparation or cooking |
| Near any sink | Receptacles within 6 feet of the top inside edge of the bowl |
| Near a tub or shower | Receptacles within 6 feet of the outside edge of the bathtub or shower stall |
| Laundry areas | Every receptacle, including the 240 volt dryer receptacle |
| Garages and accessory buildings | Receptacles where the floor is at or below grade and the space is used for storage, work or similar use |
| Basements | Every receptacle, finished or unfinished |
| Crawl spaces | Receptacles at or below grade, and the lighting outlets there too |
| Outdoors | Every receptacle, and outdoor outlets that supply equipment (see below) |
| Boathouses | Every receptacle |
| Indoor damp and wet locations | Every receptacle |
Two changes surprise people most. In the 2023 NEC, the kitchen rule no longer depends on whether a receptacle serves the countertop; every receptacle in the kitchen counts. And because the rule reaches up to 250 volts, the dryer receptacle in a laundry area now needs GFCI protection just like the washer receptacle next to it.
GFCI requirements for appliances, plugged in or hardwired
The list above is about receptacles. Section 210.8(D) adds a list of appliances whose branch circuit needs GFCI protection whether they plug in or are hardwired. The hazard is the appliance, not the plug, so wiring it directly does not make the requirement go away.
For homes, the appliances that matter are dishwashers, electric ranges, wall mounted ovens, counter mounted cooktops, clothes dryers, microwave ovens and sump pumps, as long as they are rated 150 volts or less to ground and 60 amps or less. The ranges, ovens, cooktops, dryers and microwaves were added in the 2023 NEC. In practice, a new electric range or dryer usually means a two pole GFCI breaker in the panel.
Outdoor equipment and the air conditioner deadline
The GFCI requirements for the outside of the house are in Section 210.8(F), added in the 2020 NEC, which requires GFCI protection for outdoor outlets at a home. The NEC defines an outlet as any point where current is taken to supply equipment, so this covers hardwired outdoor equipment too, including the condensing unit of an air conditioner or a heat pump.
That caused trouble. Modern inverter driven units could trip ordinary GFCIs without any real fault, leaving a house without cooling in a heat wave. The code added a temporary exception for listed HVAC equipment, and that exception expired on September 1, 2026. The HVAC industry asked for an extension to 2028, and whether your area enforces the new rule depends on the code edition and amendments your state and city use.
The 2026 NEC keeps the requirement, raises the limit for outdoor outlets from 50 to 60 amps, and allows a special purpose device, a Class C SPGFCI, for listed HVAC equipment. It also says that when equipment on a covered outdoor outlet is replaced, the outlet has to get GFCI protection. If you are replacing an air conditioner or heat pump, ask your contractor which protection they plan to use and whether it has been checked with the unit’s manufacturer.
Does an older house have to be updated?
Generally, no. GFCI requirements in the NEC apply to new work, so a house built under an older edition does not have to be rewired every time the code changes. But there are three moments when the current rules catch up with you.
When you replace a receptacle. If you replace a receptacle in a location that requires GFCI protection today, the replacement has to be GFCI protected. Swapping a worn outlet next to the kitchen sink for an ordinary one is not allowed.
When you remodel or add a circuit. New work follows the code edition your jurisdiction uses now, and a permit brings an inspector to check it.
When you sell. A home inspector will flag missing GFCI protection in wet areas as a safety item, even if the house was legal when it was built. Missing GFCI protection near water is one of the most common findings, and it is on our list of the 22 findings in every electrical inspection report.
Older houses often have two wire circuits without a ground. A GFCI receptacle can replace an ungrounded outlet there and gives real shock protection, but it does not create a ground, and the outlets it protects must be labeled “No Equipment Ground.” What that means for the rest of an older system is covered in old house wiring: do you really need to rewire?
GFCI outlet or GFCI breaker?
Both meet the GFCI requirements; the choice is practical.
A GFCI receptacle protects itself and every outlet wired after it on the LOAD terminals. It is cheap, easy to reset where you use it, and the usual choice for kitchens and bathrooms. The catch: if it sits upstream of other outlets, you may have to hunt for the one GFCI that tripped.
A GFCI breaker protects the whole circuit from the panel. It is the normal choice for 240 volt appliances such as a range or dryer, and for outdoor equipment. It takes more space in the panel, and in a panel that is already full, adding several of them can become a problem of its own.
Some equipment has its own rules on top of 210.8. A hot tub, for example, needs GFCI protection under Article 680, usually as a two pole GFCI breaker in a spa panel near the tub. That is explained in hot tub wiring: what the circuit, the GFCI and the disconnect need.
Test your GFCIs once a month
Meeting the GFCI requirements on paper means little if the device no longer works. A GFCI is a small electronic device, and it can fail. Press the TEST button: the power should go off. Press RESET to bring it back. If nothing happens when you press TEST, the device is no longer protecting anyone and should be replaced. Most manufacturers recommend doing this every month.
A GFCI that trips often is usually telling you something: water in an outdoor box, an old appliance with a heating element that leaks current, or a wiring mistake such as a neutral shared between two circuits. Resetting it over and over is not a fix. Have an electrician find the cause.
GFCI requirements: the short version
GFCI requirements follow the water. Bathrooms, kitchens, laundry areas, basements, garages, crawl spaces, the outdoors and anywhere within 6 feet of a sink or tub need GFCI protection, and since the latest editions that includes 240 volt receptacles and hardwired appliances such as ranges, dryers and dishwashers. Outdoor air conditioners and heat pumps are now covered too, where the new rule is enforced. An existing house does not have to be updated overnight, but every replaced receptacle in these places must be GFCI protected.
Because states and cities adopt the NEC at their own pace, and some change parts of it, the edition your local inspector enforces decides what applies to your home.
This article is general information about residential electrical systems, not a code ruling for your home. Code adoption varies by state and city, and your local electrical inspector has the final word. Have any work done by a licensed electrician.
Who writes this
FIXMIRO is written by Rahmouni, an industrial engineer who spent fifteen years inspecting electrical installations and seven inspecting gas. What you read here is what he used to explain to homeowners while standing at their panel, written out properly.
Use the free calculatorsOr browse all the guides.
